AEM Performance Electronics 30-3431 Скачать руководство пользователя

Страница: 4 / 8

Page 4

2. Next remove the pin from the plastic connector by lightly prying on the plastic tabs that

secure the pin in the plastic connector while gently pulling on the wire at the same time as
shown in figures 4 and 5.

Figure 4: Pry this tab up with the screwdriver or paper clip to release pin

Figure 5: While prying tab, gently pull wire back

Содержание 30-3431

Страница 3: ...lly pry white plastic retainer using both slots in the retainer so it disengages vertically about 1mm as shown in figures 2 and 3 please note some connectors may have a lock opposite to the wires in between the pins these can be removed simply using a pair of needle nose pliers Figure 2 Pry in these areas Figure 3 Lock that has to move up 1mm ...

Страница 4: ...ying on the plastic tabs that secure the pin in the plastic connector while gently pulling on the wire at the same time as shown in figures 4 and 5 Figure 4 Pry this tab up with the screwdriver or paper clip to release pin Figure 5 While prying tab gently pull wire back ...

Страница 6: ...NL and CANH pins into the receptacle of the plug and push in until it clicks as shown in figure 9 Figure 9 Pushing pin into ECU plug 6 Push the pin lock back into place until it is flush with the ECU plug as shown in figure 10 Figure 10 Ensure pin lock is relocked ...

Страница 7: ...ware and later To activate the AEMnet data stream open AEMTuner and go to Wizards Setup Wizard and select the AEMnet Data Stream See figure 11 below Figure 11 Selecting the AEMnet Datastream With the AEMnet enabled the Series 2 EMS broadcasts information as shown below in figure 12 Figure 12 AEMnet Data ...