4
|
DANR THP
|
DANR THPC
Headset Assembly and Fitting
1.
Rotate the earcup to gain access to the inside.
2.
Identify the right and left sides of the headset. The right DANR earplug (RED) connects to
the battery module side, and the left DANR earplug (BLUE) connects to the microphone (or
blank) module side. The inside of each earcup is also labeled “R” and “L” corresponding to
Right and Left respectively.
3.
Grasp one DANR earplug connector, and insert the connector into the receptacle inside
the appropriate earcup by aligning the red dot on the connector with the red dot on the
receptacle. Gently press the connector until it snaps in place as shown in the right picture
below.
4.
Repeat Step 3 for the remaining DANR earplug.
5.
To remove the connector, grip the knurled sleeve of the connector body and pull in the
direction indicated in the right picture below. DO NOT pull on the earplug cable.
Connecting DANR Earplugs to Headset
The headband is assembled to
slide for adjustment at the factory.
The friction required to adjust the
headband or to fix the headband
in place may be adjusted by
tightening or loosening the lock
nut on each side of the headband
near the headpad with an 11/32
inch or adjustable wrench.
Friction Adjustment Nut
Slides for adjustment Nut
Aegisound’s Argonaut Communication Earplugs (P/N 05-016017) may be used to offer two-way
communications without active noise reduction when DANR earplugs are unavailable. The Communication
Earplugs are compatible with Gentex’s Low Profile Custom Communications Earplugs (LPCCE) and
Aegisound’s Full Concha Custom Communications Earplugs (FCCCE) as well as Comply
™
foam eartips,
and provide double hearing protection with two-way communications.
Headband Adjustment