Page 6 of 12
CZ21554-01
3. WORKING WITH A DATACELL D
3.1. Exiting Hibernation
To allow transport and storage of the DataCell D, without concern of generating unnecessary logging
activity, the unit is placed into hibernation prior to leaving the factory. To exit hibernation hold the
DataCell D in a position whereby you can view the activity of the LED’s within the infrared
communications port and follow the following steps:-
1. Hold the magnet in the location shown in figure 3.2.1 and observe that the Yellow LED is lit. Keep
the magnet in place for approximately 10 seconds until the Orange LED illuminates.
2. Upon illumination of the orange LED remove the magnet from its position and hold it away from the
DataCell for a period of approximately 10 seconds, at the completion of which the Red LED will
illuminate.
3. Return the magnet to the original position; soon a Green LED will flash at which time you should
swipe the unit three (3) times, by moving the magnet left to right across the label as shown in figure
3.2.1. This will temporarily cause the LED’s to shut down before returning to the high power state
with both the Green and Orange LED’s Illuminated.
3.2. Waking the DataCell D
Once the DataCell D has exited Hibernation it can be woken by using the swipe magnet as follows:-
Using the Swipe Magnet from the IRC Starter Kit, swipe the magnet over the side of the unit directly in
line with the IRC port using a downward swiping action, see fig 3.2.1.
Figure 3.2.1 Waking the DataCell D
Swipe Magnet
Содержание DataCell D
Страница 1: ...INSTRUCTION MANUAL DataCell D ...
Страница 11: ...Page 11 of 12 CZ21554 01 NOTES ...