When grinding do not apply pressure on the tool but use it with gentle reciprocating
movements.
For best results when roughing-down keep the disk at an angle of at least
to the
working surface.
Overloading the machine when grinding will damage the angle grinder and results
in faster wearing out of the disks. Grinding performance will suffer.
Never use a cutting disc for grinding. Do not subject cutting discs to side pressure.
Do not tilt the angle grinder when separating. The cutting disk must have a clean
edge.
When separating stone the guide shoe must be used!
When surface grinding use a plastic backing pad with an abrasive disk.
For removing rust or old coats of paint it is recommended to use a steel brush
(saucepan brush).
Keep the machine and the ventilation slots clean.
Use only AEG accessories and spare parts. Should components need to be re-
placed which have not been described, please contact one of our AEG service
agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state the ten-digit
No. as well as the machine type printed on the label and order the drawing at your
local service agents or directly at:
Atlas Copco Elektrowerkzeuge
Postfach 320, D-71361 Winnenden.
Please refer to page 2-3 for range of accessories. Further accessories with part
numbers are shown in our catalogues.
WS
15, WS
WS
WSE
