WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
error code and the Start/Pause button may flash continuously:
Error code
Possible cause
Remedy
E50
Appliance motor overloaded.
Too much laundry or entrap in the
drum.
The programme was not comple‐
ted. Remove the laundry from the
drum, set the programme and re‐
start the cycle.
E90 or E91
Internal fail. No communication be‐
tween electronic elements of the
appliance.
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance off
and on again.
If the error code appears again,
contact the Authorised Service
Centre.
EH0
The mains supply is unstable.
When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
11.2 Troubleshooting
Problem
Possible cause
Remedy
The tumble dry‐
er does not op‐
erate.
The tumble dryer is not connected
to the mains supply.
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
The door is open.
Close the door.
The On/Off button was not pushed. Push the On/Off button.
The Start/Pause button was not
touched.
Touch the Start/Pause button.
The appliance is in standby mode. Push the On/Off button.
www.aeg.com
20
Содержание T6DBG821N
Страница 1: ...USER MANUAL EN User Manual Tumble Dryer T6DBG821N T6DBG822N ...
Страница 26: ......
Страница 27: ......
Страница 28: ...www aeg com shop 136947504 A 112023 ...