AEG SCB61811LS, Руководство пользователя

Страница: 29 / 68

Problem Possible cause Solution
The water outlet is clog-
ged. Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the
evaporative tray above the
compressor. Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The "Frostmatic function"
is switched on. Switch off "Frostmatic func-
tion" manually, or wait until
the function resets automati-
cally to set the temperature.
Refer to "Frostmatic function".
The temperature in the ap-
pliance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tem-
perature is too high. Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are
stored at the same time. Add less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm. Defrost the appliance.
The door has been
opened often. Open the door only if necessa-
ry.
The "Frostmatic function"
is switched on. Refer to "Frostmatic function".
There is no cold air circula-
tion in the appliance. Make sure that there is cold air
circulation in the appliance.
All the temperature setting
LEDs flash at the same time. An error has occurred in
measuring the tempera-
ture. Contact the nearest Author-
ised Service Centre. The cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
8.2
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
ENGLISH 29