15
GB
Your fridge-freezer needs air
The refrigerating unit does not require any maintenance.
All it needs is proper ventilation. Air intake takes place
through the base of the upright kitchen unit.
Provision for air outlet must be made at the top
behind the upright kitchen unit. In such a unit, a
clear air inlet and outlet cross-section of at least
200 cm
2
must be provided in the base and towards
the room ceiling.
Ensure that these openings are not obstructed by
base panels, etc.!
Before using for the first time
In common with all new appliances, your fridge-
freezer will smell "new". For this reason, the interior
of the fridge-freezer and all accessories should be
cleaned before use (see also "Cleaning and care").
Electrical connection
WARNING - THIS APPLIANCE MUST BE
EARTHED
Please ensure that the voltage and current indicated
on the rating plate agree with the voltage of your
electricity supply.
220/240 volts (i. e. 220/240 V AC).
If your appliance has been equipped with a mains
lead with a moulded-on type plug, you must comply
with the following regulations: The plug moulded on
to the cord incorporates a fuse. For replacement,
use a 13 amp BS 1362 fuse. Only ASTA approved
or certified fuses should be used. The fuse cover/
carrier must be replaced in the event of changing
the fuse. The plug must not be used if the fuse
cover/ carrier is lost. A replacement cover/carrier
must be obtained from an electrical goods retailer. If
the socket outlets in your home are not suitable for
the plug fitted to the appliance, then the plug must
be cut off and an appropriate one fitted. When
fitting the plug please note the following points:
Important
The wires in the mains lead are coloured in accord-
ance with the following code:
Green and Yellow
Earth
Blue
Neutral
Brown
Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
1. The wire which is coloured green and yellow
must be connected to the earth terminal in your
plug, which is marked with the letter E or by the
earth symbol
or coloured green, or green
and yellow.
2. The wire which is coloured brown must be con-
nected to the live terminal which is marked with
the letter L or coloured red.
3. The wire which is coloured blue must be con-
nected to the neutral terminal which is marked
with the letter N or coloured black.
When wiring the plug, ensure that all strands of wire
are securely retained in each terminal. Do not forget
to tighten the mains lead clamp on the plug.
Warning! A cut-off plug inserted into a 13 amp
socket is a serious safety (shock) hazard. Ensure
that the cut-off plug is disposed of safely.
Voltage
220/240 V AC
Fuse rating
13 amps
See rating plate for further information.
The rating plate is inside, on the left.
Preparing the upright kitchen
unit
Fig. 2
Before installing the upright furniture unit, the back
panel must be removed where fitted as a transport
safety device.
To ensure satisfactory operation and sealing of the
appliance, the upright kitchen unit with its interme-
diate panels must be exactly at right-angles in all
directions and must be aligned vertically.
The doors of the upright kitchen unit should be
aligned before the appliance is installed, and the
hinge screws should be tightened.
The distance between the kitchen unit door and unit
sides should be 1 mm.
Rehingeing the door
Figs. 3, 4, and 5
During transport, the doors are secured with bolts.
Unscrew the LH upper and lower bolts with a
screw-driver
(Fig. 3)
. Both doors can now be
opened to the right.
If the doors are to be opened to the left to ensure
better operation, you should also unscrew the bolts
on the RH side and unhinge the upper door
upwards.
