AEG S33400CSS0, Руководство пользователя

Страница: 29 / 52

Problem Possible cause Solution
The lamp is defective. Refer to "Replacing the
lamp".
If your appliance is still not working
properly after making the above checks,
contact the After Sales Centre.
7.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
1. Disconnect the appliance.
2. Push the movable part to unhook
the lamp cover (1).
3. Remove the lamp cover (2).
4. If needed replace the lamp with a
light of similar characteristic and
power. It is suggested to use Osram
PARATHOM SPECIAL T26 0.8 Watts.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the
lamp comes on.
1
2
7.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
8. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
8.2 Location
The appliance should be installed well
away from sources of heat such as radia-
tors, boilers, direct sunlight etc. Ensure
that air can circulate freely around the
back of the cabinet. To ensure best per-
formance, if the appliance is positioned
below an overhanging wall unit, the min-
imum distance between the top of the
cabinet and the wall unit must be at least
100 mm . Ideally, however, the appliance
should not be positioned below over-
hanging wall units. Accurate levelling is
ensured by one or more adjustable feet
at the base of the cabinet.
ENGLISH
29