AEG PowerCare LR86CB86, Руководство пользователя

Страница: 16 / 48

7.3 Introduction
The options/functions are
not selectable with all
washing programmes.
Check the compatibility
between options/functions
and washing programmes in
the "Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allow you
to set the incompatible
options/functions together.
Make sure the screen and
touch buttons are always
clean and dry.
7.4 Finish In
Set this option as last after
programme and other
options selection, otherwise
it can be cancelled if you
change some setting.
This option allows choosing the time
within which a programme should
terminate. The programme end can be
postponed by one 1 hour every button
touch until 24 hours maximum.
The display shows the normal
programme duration alternatively with
the set programme end time (expressed
in hours 0h). The minimum selectable
time corresponds to rounded up hour of
the maximum duration of a programme
(e.g. if the cycle duration lasts 3:15
hours, the minimum selectable time will
be 4h).
After programme start, the door is locked
and the appliance starts the ProSense
phase. When load estimation ends, on
the display the icon of running phase
blinks and the time digit counts down in
steps of one hour and in steps of 1
minute during the last hour.
7.5 Start / Pause
Touch the Start / Pause button to
start, pause the appliance or interrupt a
running programme.
7.6 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
The recommended maximum load
decreases on the display.
The indicator blinks on the display
during steam phase.
This option can affect the
programme duration.
When the programme stops the display
shows a zero , the indicator is
steady on and the indicator
starts
blinking, and the Start / Pause led
remains lit. The drum performs smooth
movements for about 30 minutes to keep
the steam benefit. By touching any
button the anti-crease movements stop
and the door unlocks, the appliance
proposes again the previous set
programme.
To interrupt the anti-crease phase, you
can also:
• Press the On/Off button for a few
seconds to activate or the deactivate
the appliance.
• Turning the programme dial in
another position.
An half laundry load helps to
reach better results.
7.7 Extra Rinse
With this option you can add a few rinses
to the selected washing programmes and
optimise the fabric softener distribution
and improve the fabric softness.
It is suggested when you use the fabric
softener.
Useful for people allergic to detergents
and in areas where the water is soft.
This option increases the programme
duration.
The button indicator comes on.
www.aeg.com 16