29
Door reversal instructions
Warning!
The door stop may only be changed by a specialist. If
necessary,please contact our after-sales service or your specialist dealer.
Warning!
Before changing the door stop, disconnect the mains plug;
with a permanent connection: fully unscrew or deactivate the fuse.
1. Open loading door
.
2. Unscrew hinge A from the front ofthe
machine and take off the loading door.
3. Remove cover plates B and C. To do this,
insert a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pres-
sure to unfasten locking block D from
the snap-on fixture, take out and reins-
ert on the other side, having rotated the
block through 180°.
5. Unscrew hinge A from the loading door,
rotate through 180°, reinsert on the
opposite side and screw down.
6. Reinsert cover plates B and C on the
opposite site having first rotated them
through 180°.
7. Unscrew cover plates E from the front of
the machine, rotate through 180, screw
on the opposite side.
8. Unscrew door lock F, push down slightly
and remove from the front of the
machine.
9. Press snap-in button G in and down,
press cover down slightly and remove
from front of the machine.
10. Transfer door lock F to the oppositesi-
de and screw down.
11. Fix cover G on to the other side and
allow the snap-in button to lock in
place.
12. Insert loading door and hinges into recesses on the front of the machine
and screw down.
125985032.qxp 2006-07-17 11:16 Page 29
