AEG LAVATHERM 76385AH3, Руководство пользователя

Страница: 16 / 24

9.10 Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is completed, the
symbol flashes on the display. If the
Buzzer option is on, the acoustic signal
sounds intermittently for 1 minute.
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off button for 2
seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
10.
HINTS AND TIPS
10.1
Ecological hints
• Spin good the laundry before drying.
• Use the load volumes which are
specified in the programme chart.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g.
with a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
10.2
Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3.
Select 1 of available programmes.
4.
Push at the same time and hold
down the
Dry Plus
and
Anticrease
buttons.
One of the symbols goes into the view
on the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5.
Push the
Start/Pause
button again
and again until you set necessary
degree.
6. To memorise the setting, push at the
same time the Dry Plus and
Anticrease buttons for
approximately 2 seconds.
10.3 Deactivating the Tank
indicator
The water container indicator is by
default on. It starts to light at the end of
the drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and indicator can be
permanently off.
To deactivate the indicator:
1.
Turn on the appliance.
2.
Wait approximately 8 seconds.
3.
Select 1 of available programmes.
4. Push at the same time and hold
down the Dry Plus and Buzzer
buttons.
One of 2 configurations is possible:
• the Tank indicator: is on and the
symbol goes into the
view - the water container
indicator is permanently on
• the Tank indicator: is off and the
symbol goes into the
view - the water container
indicator is permanently off
www.aeg.com 16