Problem
1)
Possible cause
Remedy
Abnormally
elapsing
time on the
display.
The time to end is calculated on
the basis of the volume and
dampness of the laundry.
The automatic procedure — this
is not the appliance malfunction.
Programme
inactive.
The water container is full.
Drain the water container
3)
,
push the Start/Pause button.
Drying cycle
too short.
Too small laundry volume.
Do the selection of time pro-
gramme. The time value must
be related to the load. To dry
one item or small quantities of
the laundry we recommend to
use short times.
The laundry is too dry.
Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry )
Drying cycle
too long
6)
The filter is clogged.
Clean the filter.
Too high volume of the load.
Obey the maximum load vol-
ume.
The laundry not spun sufficient-
ly.
Spin correctly the laundry.
Very high room temperature -
this is not the appliance mal-
function.
If possible, lower the room tem-
perature.
1) If there is an error message on the display (e.g.
E51
): Turn the tumble dryer off and on.
Make a selection of the new programme. Push the Start/Pause button. Does not operate? -
contact the service centre and give the error code.
2) follow the programme description — see
PROGRAMMES
chapter
3) see
CARE AND CLEANING
chapter
4) see section
WATER HARDNESS
in
HINTS AND TIPS
chapter
5) Only the tumble dryers with drum light.
6) Note: After maximum 5 hours the drying cycle ends automatically (see
Drying cycle
complete
section).
56
