33
Care and cleaning
8.
Put the cap back on the emergency
emptying hose and place the latter
back in its seat.
9.
Screw the pump fully in.
10.
Close the pump door.
Warning!
When the appliance is in use and
depending on the programme selected
there can be hot water in the pump. Never
remove the pump cover during a wash
cycle, always wait until the appliance has
finished the cycle, and is empty. When
replacing the cover, ensure it is securely retightened so as to stop leaks and
young children being able to remove it.
Water inlet filter
If you notice that the machine is taking longer to
fill, check that the filter in the water inlet hose is
not blocked.
1. Turn off the water tap.
2. Unscrew the hose from the tap.
3. Clean the filter in the hose with a stiff brush.
4. Screw the hose back onto the tap.
Emergency emptying out
If the water is not discharged, proceed as follows to empty out the machine:
1.
pull out the plug from the power socket;
2.
close the water tap;
3.
if necessary, wait until the water has cooled down;
4.
open the the pump door;
5.
place a bowl on the floor and place the end of the emergency emptying hose
into the bowl. Remove its cap. The water should drain by gravity into the
bowl. When the bowl is full, put the cap back on the hose. Empty the bowl.
Repeat the procedure until water stops flowing out;
6.
clean the pump if necessary as previously described;
192998241 gb.qxd 9/4/2008 10:07 AM Page 33
