Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets,
rugs etc.
Before placing it on small tiles, apply a rubber coating.
Never try to correct any unevenness in the floor by
putting pieces of wood, cardboard or similar
materials under the machine.
If it is impossible to avoid positioning the machine
next to a gas cooker or coal-burning stove, an
insulating panel covered with aluminium foil on the
side facing the cooker or stove, must be inserted
between the two appliances.
The machine must not be installed in rooms where
the temperature can drop below 0.
The water inlet hose and the drain hose must not be kinked.
Please ensure that when the appliance is installed, it is easily accessible for the
engineer in the event of a breakdown.
Carefully level by screwing the adjustable feet in or out. Never place cardboard,
wood or similar materials under the machine to compensate for any unevenness
in the floor.
Water inlet
An inlet hose is supplied and can be found inside the machine drum.
Do not use the already employed hoses to connect to the water supply.
This appliance must be connected to a cold water supply.
1.
Open the porthole and extract the inlet hose.
2.
Connect the hose with the angled connection to
the machine.
Do not place the inlet hose downwards. Angle
the hose to the left or right depending on the
position of your water tap.
43
Installation
HEC007S
HEC0006
192998241 gb.qxd 9/4/2008 10:07 AM Page 43
