AEG L8FEE842, Руководство пользователя

Страница: 8 / 40

20
O
20
O
45
O
45
O
Make sure that the inlet hose
is not in vertical position.
3. If necessary, loose the ring nut to set
it in the correct position.
4. Connect the water inlet hose to the
cold water tap with 3/4" thread.
CAUTION!
Make sure that there are no
leaks from the couplings.
Do not use an extension
hose if the inlet hose is too
short. Contact the service
centre for the replacement
of the inlet hose.
3.4 Water-stop device
The inlet hose has a water stop device.
This device prevents water leaks in the
hose because of its natural ageing.
The red sector in the window «
A » shows
this fault.
A
If this occur, close the water tap and
contact the authorized service centre to
replace the hose.
3.5
Water drainage
The drain hose should stay at a height of
not less than 60 cm and not more than
100 cm.
It is possible to connect the drain hose in
different ways:
1.
Make a U shape with the drain hose
and put it around the plastic hose
guide.
2. On the edge of a sink - Fasten the
guide to the water tap or to the wall.
Make sure that the plastic
guide cannot move when
the appliance drains.
www.aeg.com 8