13.8
Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (9) of
'Cleaning the drain filter'. If necessary,
clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate again the drain system:
1.
When you drain the water with the
emergency drain procedure, you
must activate again the drain system:
Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2.
Start the programme to drain the
water
13.9
Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from
the inlet hose and the drain pump.
1.
Disconnect the mains plug from the
mains socket.
2.
Close the water tap.
3.
Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4.
Empty the drain pump. Refer to the
emergency drain procedure.
5.
When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the
temperature is more than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
14.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
14.1
Introduction
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
- The appliance does not fill with
water properly.
•
- The appliance does not drain
the water.
•
- The appliance door is open or
not closed correctly. Please check the
door!
•
- The mains supply is unstable.
Wait until the mains supply is stable.
•
- No communication between
electronic elements of the appliance.
Switch off and switch on again.
•
- The anti-flood device is on.
Disconnect the appliance and close
the water tap. Contact the Authorised
Service Centre.
WARNING!
Deactivate the appliance
before you do the checks.
14.2
Possible failures
Problem
Possible solution
The programme does
not start.
Make sure that the mains plug is connected to the mains sock-
et.
ENGLISH
31
Содержание L 87696 WD
Страница 1: ...EN User Manual Washer Dryer L 87696 WD ...
Страница 30: ...3 4 1 2 5 1 2 6 7 8 1 2 9 1 2 www aeg com 30 ...
Страница 36: ...www aeg com shop 132901350 A 082015 ...