14
Operation – Installation
4.3 Restricting the control switches
At the rear of the operating unit there are 3 pins with which
you can fix or restrict the settings of the sliding switch and
temperature control knob.
D
00000
47
39
3
1
2
1 Temperature selector
2 Sliding switch
P Pin holder
B
Fixing the temperature control knob to a specific
temperature
L
Restricting the temperature control knob to a specific
temperature range
M
Fixing the sliding switch to a specific operating mode
5.
Cleaning, care and
maintenance
The appliance contains no user serviceable parts.
» Clean the appliance when cold with ordinary clean-
ing products.
» Avoid abrasive or corrosive cleaning products.
» If a pale brownish discolouration appears on the ap-
pliance casing, wipe it off with a damp cloth.
» Regularly clean the upper and lower ventilation
grilles of the appliance with a vacuum cleaner.
!
Material losses
Never spray cleaning spray into the air slot.
6. Troubleshooting
Problem
Cause
Remedy
The appli-
ance does
not heat
up.
The temperature is set
too low.
Check the temperature set on
the appliance.
The power supply has
been interrupted.
Check the MCB/fuse in your
fuse box/distribution panel.
The appliance has
overheated. The high
limit safety cut-out has
switched the appliance
off.
Remedy the cause, such as
a covered or dirty air outlet or
intake.
After a few minutes of cooling
down the appliance will restart.
If you cannot remedy the fault, notify your qualified con
-
tractor. To facilitate and speed up your request, provide
the number from the type plate (000000-0000-000000).
INSTALLATION
7.
Safety
Only a qualified contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1
General safety instructions
We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
7.2
Instructions, standards and regulations
Note
Observe all applicable national and regional regula
-
tions and instructions.
8.
Appliance description
8.1
Standard delivery
The following are delivered with the appliance:
◦
Wall mounting bracket
8.2 Accessories
8.2.1
Further accessories
◦
Control unit
9.
Installation
9.1
Installation site
WARNING Electrocution
Install the appliance in such a way that the control
equipment cannot be touched by a person in the
bath or shower.
!
Material losses
Fit the appliance to a vertical wall that is heat-resist
-
ant to at least 85 °C.
!
Material losses
Never install the appliance directly below a wall
socket.
!
Material losses
Maintain the minimum clearances to adjacent sur
-
faces.
≤500
≥150
≥500
≥120
≥175
D
00000
47
39
2
