Downloaded from www.vandenborre.be
To remove the dirt:
1. –
Remove immediately:
melted plastic, plastic foil, and food with sugar. If not, the dirt
can cause damage to the appliance. Use a special scraper for the glass . Put the scra
-
per on the glass surface at an acute angle and move the blade on the surface .
–
Remove after the appliance is sufficiently cool:
limescale rings , water rings, fat
stains, shiny metallic discolorations. Use a special cleaning agent for glass ceramic or
stainless steel.
2. Clean the appliance with a moist cloth and some detergent.
3. At the end
rub the appliance dry with a clean cloth.
WHAT TO DO IF…
Problem
Possible cause and remedy
You cannot activate the appli
-
ance or operate it.
• Activate the appliance again and set the heat setting in 10
seconds.
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• The Child Safety Device or the Lock or Stop+Go operates. See
the chapter Operating instructions.
• There is water or fat stains on the control panel. Clean the
control panel.
A Sound operates and the ap
-
pliance deactivates.
A sound operates when the ap
-
pliance is deactivated.
You put something on one or more sensor fields. Remove the ob
-
ject from the sensor fields.
The appliance deactivates.
You put something on the . Remove the object from the sen
-
sor field.
The residual heat indicator does
not comes on.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone should be hot, speak to the service cen
-
tre.
The Automatic Heat Up func
-
tion does not operate.
• There is still residual heat on the cooking zone. Let the cooking
zone become sufficiently cool.
• The highest heat setting is set. The highest heat setting has the
same power as the Automatic Heat Up function.
You cannot activate the outer
ring.
Activate the inner ring first.
The sensor fields become hot.
The cookware is too large or you out it too near to the controls.
Put large cookware on the rear cooking zones if it is necessary.
There is no signal when you
touch the panel sensor fields.
The signals are deactivated. Activate the signals (see OffSound
Control).
comes on
The Automatic Switch Off operates. Deactivate the appliance and
activate it again.
What to do if…
29
