13
Installation – for qualified contractors
WARNING Burns
Parts of the appliance can get very hot and may
cause burns.
Particular caution is advised when
children or vulnerable persons are present.
WARNING Burns
◦
Never place any objects on top of the appliance.
◦
Do not lean any objects against the appliance.
◦
Never place any objects between the appliance
and the wall.
◦
Do not place any flammable, combustible or
insulating objects or materials, such as laundry,
blankets, magazines, containers with floor pol
-
ish or naphtha, spray cans or similar, in close
proximity to the appliance.
Never cover the appliance
Even covering up a section, for example with a towel,
can cause overheating and damage the heating el
-
ement.
◦
Never cover the appliance.
◦
Never stick anything onto the appliance
(e.g. decorative foil, post-it notes).
!
Material losses
Observe the minimum clearances (see chapter
"Specification / Minimum clearances").
!
Material losses
Never operate the appliance when the toughened
safety glass or other components are damaged.
2.3 Test symbols
See type plate on the appliance. The type plate is locat-
ed on the outer edge of the appliance near the ON/OFF
switch.
3.
Appliance description
The appliance is a wall mounted electric heating plate
made of toughened safety glass.
A heating mat is glued to the back of the glass plate which
warms the plate evenly.
The heat stored in the glass plate is delivered as infra-red
radiation. Consequently, occupants and objects alike are
heated in the room without any air turbulence.
Note
Never place objects between the appliance and
persons requiring heating.
In this case, the objects
would be heated rather than the persons.
3.1
Toughened safety glass plate
!
Material losses
Never operate the appliance when the toughened
safety glass is damaged.
The front of the appliance is made of 6 mm thick tough-
ened safety glass.
If damaged, the safety glass will shatter into many small
pieces with blunt edges to minimise any risk of injury.
On very rare occasions, safety glass can spontaneously
break even without external influences.
◦
Avoid any strain on the glass plate, e.g. caused by
people or objects leaning on it.
◦
When selecting an installation site, ensure that no
persons or objects can come to harm if the tough-
ened safety glass spontaneously breaks.
Note
Raw mirror glass and cast glass are subject to spe
-
cial manufacturing processes.
Spherical or linear
inclusions and blisters due to a roll change and pat
-
tern offset cannot be excluded and do not constitute
a quality defect.
4. Settings
CAUTION Burns
When pressing the ON/OFF switch, avoid any con
-
tact with the potentially hot glass plate.
Note
Depending on the size and design of the appliance,
it may take some time for it to reach its operating
temperature.
Note
When the appliance is first commissioned, it may
give off an odour temporarily.
»
Ensure that the room is adequately ventilated
(with a partially open window, for example).
The ON/OFF switch is located on the outer edge of the
appliance.
D
00000
55
94
3
1
1 ON/OFF switch
» Switch the appliance on or off using the ON/OFF
switch.
After reaching the operating temperature, the appliance
heats constantly at around 100 °C.
You can operate the appliance with an optional wall
mounted room thermostat.
» Observe the operating and installation instructions of
the connected room thermostat.
