AEG FSE62417P, Руководство пользователя, Страница: 23 / 56

Problem and alarm code Possible cause and solution
The appliance does not
drain the water.
The display shows
i20 .
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clogged.
• Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
The display shows
i30 .
• Close the water tap.
• Make sure that the appliance is correctly installed.
• Make sure the baskets are loaded as instructed in the
user manual.
Malfunction of the water lev-
el detection sensor.
The display shows
i41 - i44 .
• Make sure that the filters are clean.
• Switch the appliance off and on.
Malfunction of the wash
pump or the drain pump.
The display shows
i51
-
i59
or
i5A
-
i5F
.
• Switch the appliance off and on.
The temperature of the wa-
ter inside the appliance is
too high or malfunction of
the temperature sensor oc-
curred.
The display shows
i61 or
i69 .
• Make sure that the temperature of the inlet water does
not exceed 60°C.
• Switch the appliance off and on.
Technical malfunction of the
appliance.
The display shows
iC0 or
iC3 .
• Switch the appliance off and on.
The level of water inside the
appliance is too high.
The display shows
iF1 .
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation instruc-
tions.
The appliance stops and
starts more times during op-
eration. • It is normal. It provides optimal cleaning results and en-
ergy savings.
The programme lasts too
long. • If the delay start option is set, cancel the delay setting or
wait for the end of the countdown.
• Activating options can increase the programme dura-
tion.
The remaining time in the
display increases and skips
nearly to the end of the pro-
gramme duration. • This is not a defect. The appliance is working correctly.
ENGLISH 23