AEG EDW1103, Руководство по обслуживанию, Страница: 33 / 59

SOE/PR 33 599 72 48-93
•
Time limit set: 10 sec.
“i80” Code - family : Auto Door Opener
“i80” – code: Auto door opener malfunction
•
the error is set if the auto door opener sense signal indicates that it has left the normal position
unintentionally while running a cycle,
•
or if the auto door opener times out without reaching starting position three times while retracting.
•
Timeouts are defined in MCF
•
abort program and display error
“i81” – code: Auto door opener warning
•
the warning is set if the auto door opener sense signal indicates that it has left the normal position
unintentionally,
•
or if the auto door opener times out while opening the door and does not leave the starting position,
•
or if the auto door opener reverses direction while opening the door and reach the inside position
before expected (door blocked),
•
or if the auto door opener times out while retracting.
•
Timeouts are defined in MCF
•
the warning is not displayed, the cycle continues
“i90” Code - family : Configuration Problem
“i91” – code: checksum MCF
•
No washing program start is possible, can be resolved by turning the appliance off and back on again.
•
The display board does not satisfy the identification requests of the main board.
“i92” – code: checksum CCF
•
The alarm is signalled if the configuration control of the washing cycles provided erroneous results.
“iB0” Code - family : Sensor Problem
“iB0” - code: turbidity sensor
•
The alarm is set if the calibration procedure is not completed after 15 sec.
•
The washing program will run as though the dirt value to be considered is high
“iC0” Code - family : Communication Problem
“iC0” – code: user interface communication
•
The error signal is displayed if there is not communication recognize between UI board and main
board. The error is displayed only in run time but not saved.