English
42
Insert Batteries into the Remote
Control
Audio-/Video cords
The distance between the retaining jigs for wall mounting is 120 mm.
1.
Drill two holes horizontally in this distance.
2.
Insert dowels and screws.
3.
Hang the device onto the screws. Check a secure grip.
4.
Connect the device to a correctly installed power socket.
Operation
WARNING:
Leaking battery acid may cause a health hazard. Remove batteries
from the remote control when depleted or the unit is not in use for an
extended period of time. Clean up any leakage with a cloth immediately.
In the event of skin contact, rinse the affected area immediately. In case
of ingestion consult a physician immediately. In the event of eye contact,
rinse eyes and consult a physician immediately.
CAUTION:
Different battery types or new and used batteries may not be used
together. Dissimilar batteries feature dissimilar qualities. Do not use old
and new batteries together. Combined use of old and new batteries may
shorten the life span of the new batteries and may cause leakage of the
old batteries. Upon disposal, adhere to the recycle and environmental re-
gulations of your respective country. Never throw batteries into open fire.
NOTE:
The life span of the enclosed batteries may be reduced due to storage.
1.
Open and remove the lid from the battery compartment.
2.
Place two batteries Type AAA/R03 (1.5 V) in correct polarity
(+ and -) into the battery compartment. Always start with the nega-
tive pole (-).
3.
Replace and close the battery compartment lid.
NOTE:
The signals of the remote control are transmitted to the DVD-Player
by infra-red light. Ensure that the DVD-Player is not exposed to direct
sunlight. This may render the signal transmittal from the remote
control to the DVD-Player impossible.
Range of the remote control unit
To use the remote control, aim it at the remote control sensor on the
display on the left front side of the device. The distance of the remote
control to the sensor should not exceed 5 meters. The angle of the
remote control unit to the sensor surface should not exceed 30° in any
direction.
NOTE:
An undisturbed operation can be guaranteed only with Audio/Video
lines up to 1.5 m length.