AEG CF 2.., Руководство по эксплуатации

Страница: 39 / 100

g
39
13.4 Cleaning the Coffee-making Unit
We advise you to clean the coffee-
making unit regularly (depending on
how frequently it is used). It should be
cleaned before you start the cleaning
program. If your coffee machine is to
be left unused for some time (e.g. holi-
days), empty the coffee grounds con-
tainer and the water tank, and
throroughly clean the coffee machine,
including the coffee-making unit.
Removing the coffee-making unit
0
Press the "On/Off" key (Fig. 3, h) to
switch the coffee machine off. Unplug
from the mains socket.
0
Pull the coffee grounds container com-
pletely out of the coffee machine
(Fig. 26) .
0
Press the Service cover release button
(Fig. 2, S)
(Fig. 27) .
The service cover opens at the front
(Fig. 28) .
0
Remove the service cover.
The coffee-making unit is located
behind the service cover
(Fig. 29) . The
three red elements are used for latch-
ing and unlatching.
0
To remove the coffee-making unit,
operate the latches in the following
order
(Fig. 30) :
1. Push the latching lever up.
2. Press and hold the lock button.
3. Press and hold the latching button
down and pull out the coffee-making
unit
(Fig. 31) .
Cleaning the coffee-making unit
0
To clear coarse particles (contamina-
tion) from the coffee-making unit, pull
the white service lever down to the
stop and open the coffee-making unit
(Fig. 32) .
The two strainers and now readily
accessible, and the ejector lever drops
down.
0
Rinse the coffee-making unit under
warm, running water. It is essential to
thoroughly flush the stainless steel
strainers to remove all coffee residues
(Fig. 33 and 34) .
0
Dry the coffee-making unit off and
push the service lever back up to the
stop
(Fig. 35) .
The ejector lever flips in and the cof-
fee-making unit closes.
Inserting the coffee-making unit
0
Follow these steps to re-insert the cof-
fee-making unit:
1. Push the coffee-making unit onto the
guide bar and then unit into the coffee
machine as far as it will go
(Fig. 36) .
2. Press the latching button down and
slide the coffee-making unit back for
around another 1 cm until the latching
button engages
(Fig. 37) .
3. Press the latching lever down to the
stop
(Fig. 37) .
0
Replace and close the service cover,
and re-insert the coffee grounds con-
tainer.
3 The coffee machine can be switched on
only when the service cover is closed.
After the coffee machine has been
switched on, the coffee-making unit
runs through the set-up cycle, and this
is followed by the normal heating pro-
cess.
13.5 Running the Cleaning Program
The cleaning program is run to com-
pletely remove coffee grease from
inaccessible parts. Run the cleaning
program no later than when the
"Clean" key (Fig. 3, f)
indicator
flashes.
The cleaning process lasts around
8 minutes and must not be inter-
rupted.
3 Use only original AEG-cleaning tablets!
These can be obtained from AEG Cus-
tomer Service Centre (ET No. 663 910
480) or your dealer (E No. 950 078
803).
0
Before starting the cleaning program,
clean the coffee-making unit (refer to
„Cleaning the Coffee-making Unit"
Page 39) and empty the coffee grounds
container. Fill the water tank with at
least 1 litre fresh water.