AEG C88000M, Инструкция по установке и эксплуатации

Страница: 27 / 33

Installation Instructions
111
1
Safety Instructions for the Installer
• This hob must be installed by qualified personnel, according to the
manufacturer’s instructions and to the relevant country standards.
• In respect of fire protection, this appliance corresponds to type Y (IEC
335-2-6). Only this type of appliance may be installed with a high
cupboard or wall on one side.
• It is not permitted to fit drawers below the cooking surface.
• Protection against electric shock must be provided by the installa-
tion.
• The kitchen unit in which the appliance is fitted must satisfy the
requirements of DIN 68930 in respect of stability.
• Built-in ovens and cooking surfaces are fitted with special connector
systems. They may only be combined with appliances with a matching
system.
• All cut surfaces are to be sealed with a suitable sealant for protection
against moisture.
• On tiled work surfaces, the joints in the area where the hob sits on
the surface must be completely filled with grout.
• On natural, artificial stone, or ceramic tops, the snap action springs
must be bonded in place.
• Ensure that the seal is correctly seated in the frame and that it is sea-
ted against the work surface without leaving any gaps. Additional
silicon sealant must not be applied, this will make removal more diffi-
cult in the event of the need for service.
• To remove the hob, it must be pressed out from below.
Electrical connection
• Connect the wiring harness plugs with the respective sockets of the
same colour of the built-in oven or switch box.
3
This induction glass ceramic cooking zone can only be combined
with the following AEG units:
Competence E 8. . .
Competence E 6. . .
Competence E 4106-1
Competence S 8. . .
947344.book Seite 111 Mittwoch, 11. Juli 2001 2:15 14