AEG BE6915001M, Руководство пользователя

Страница: 23 / 80

ENGLISH 23
11.3 Oven Installation
For all ovens. after the power has been
connected:
1 Position the oven inside the unit and
en-sure that the power cable is not
trapped or in contact with parts of the
oven that heat up.
2 Anchor the oven to the unit with the
screws supplied, screwing them into
the unit through the holes that can be
seen when the door is open.
3 Make sure that the body of the oven
is not in contact with the walls of the
unit and that there is a separation of
at least 2 mm with the adjacent units.
11.4 Technical information
If the appliance does not work, inform
Technical Service of the kind of problem
you are experiencing and give the:
1 Serial Number (S-No)
2 Model of Appliance (Mod.)
You will find this information engraved on
the identification plate. This plate is on the
bottom of the oven and can be seen when
open-ing the door.
• Disconnection from the electrical
supply must be allowed after the oven
is in the installed position.
• With built-in multifunction ovens, the
rear of the unit, corresponding to the
shaded area (A), must have nothing
projecting out (unit reinforcement,
pipes, sockets, etc.).
• The adhesive used in the plastic lining
the kitchen units must be able to
withstand temperatures over 85ºC.
11.2 Electrical Connection
The installer must ensure that:
• The mains power voltage and
frequency correspond to what is
marked on the identification plate.
• The wiring system can withstand the
maximum power marked on the
identification plate.
• After connecting the power, check
that all electrical parts of the oven are
working correctly.
23
450
3172742-002 In-Fr. (AEG) 17/10/14 09:50 Página 23