AEG ABE6821VNF, Руководство пользователя

Страница: 11 / 16

Problem Possible cause Solution
Water flows on the floor. The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor. Attach the melting water
outlet to the evaporative
tray.
Temperature cannot be set. The FROSTMATIC function
is switched on. Switch off FROSTMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FROSTMATIC function"
The temperature in the ap-
pliance is too low/too high. The temperature regulator is
not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tempera-
ture is too high. Let the food products tem-
perature decrease to room
temperature before storage.
Many food products are
stored at the same time. Store less food products at
the same time.
The door has been opened
often. Open the door only if neces-
sary.
The FROSTMATIC function
is switched on. Refer to "FROSTMATIC
function".
There is no cold air circula-
tion in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
Door does not open easily. You attempted to re-open
the door immediately after
closing. Wait a few seconds between
closing and re-opening of
the door.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.
7.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
8.
INSTALLATION
WARNING!
Refer to Safety chapters.
ENGLISH 11