• Adequate air circulation should be around the appliance, lacking this leads to overheat-
ing. To achieve sufficient ventilation follow the instructions relevant to installation.
• Wherever possible the back of the product should be against a wall to avoid touching
or catching warm parts (compressor, condenser) to prevent possible burn.
• The appliance must not be located close to radiators or cookers.
• Make sure that the mains plug is accessible after the installation of the appliance.
• Connect to potable water supply only.
9)
Service
• Any electrical work required to do the servicing of the appliance should be carried out
by a qualified electrician or competent person.
• This product must be serviced by an authorized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses which could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The appliance shall not be discarded together
with the urban refuse and rubbish. The insulation foam contains flammable gases: the
appliance shall be disposed according to the applicable regulations to obtain from your
local authorities. Avoid damaging the cooling unit, especially at the rear near the heat
exchanger. The materials used on this appliance marked by the symbol are recyclable.
CONTROL PANEL
1
2
3
4
5
1
Green On/Off Indicator Light
2
Temperature Regulator and On/Off Switch
3
Yellow Fast Freeze Indicator Light
4
Acoustic Signal Stop and Fast Freeze Switch
5
Red Alarm Indicator Light
Switching on
1. Allow the appliance to stand for 4 hrs after installation.
2. Insert the plug into the wall socket.
3. Turn the Temperature Regulator clockwise to a temperature lower than <<
-
16 °C
>> position.
4. The Green On/Off Indicator Light will light up and Red Alarm Indicator Light will blink.
9) If a water connection is foreseen
20
Control panel
Содержание A60120GS4
Страница 62: ...62 ...
Страница 63: ...63 ...
Страница 64: ...www aeg electrolux com shop 200383543 A 242010 ...