AEG 6130M, Руководство по эксплуатации и установке

Страница: 15 / 21

Installation Instructions
69
1
Safety Instructions for the Installer
• This hob must be installed by qualified personnel, according to the
manufacturer’s instructions and to the relevant country standards.
• In respect of fire protection, this appliance corresponds to type Y (IEC
335-2-6). Only this type of appliance may be installed with a high
cupboard or wall on one side.
• It is not permitted to fit drawers below the cooking surface.
• Protection against electric shock must be provided by the installation.
• The kitchen unit in which the appliance is fitted must satisfy the
requirements of DIN 68930 in respect of stability.
• Built-in ovens and cooking surfaces are fitted with special connector
systems. They may only be combined with appliances with a matching
system.
• All cut surfaces are to be sealed with a suitable sealant for protection
against moisture.
• On tiled work surfaces, the joints in the area where the hob sits on
the surface must be completely filled with grout.
• On natural, artificial stone, or ceramic tops, the snap action springs
must be bonded in place.
• Ensure that the seal is correctly seated in the frame and that it is sea-
ted against the work surface without leaving any gaps. Additional
silicon sealant must not be applied, this will make removal more diffi-
cult in the event of the need for service.
• To remove the hob, it must be pressed out from below.
Notes for Switzerland
Contrary to the Household Installation Regulations of the SEV, section
47330.1, the built-in ovens, hobs and cooking surfaces may be installed
in flammable materials.
Parts that project into the space underneath the hob must be made on
non-flammable materials, or be at least 100 mm from the bottom edge
of the hot plates. Flammable walls and ceilings above the cooking sur-
faces be fitted with fire retardant material in accordance with the reg-
ulations of the fire department in the respective Kanton.
The second rating plate included with the hobs and cooking surfaces
must be fitted in a location near the appliance so that it is clearly visi-
ble if required, but hidden out of sight (dust and grease free surface).