AEG 37699MO-MN, Руководство пользователя

Страница: 18 / 28

18 www.aeg.com
Positioning the cooker
The appliances are fitted with the
following parts to enable them to be
correctly positioned:
•
Adjustable feet , to be fitted to the
appliance, which allow the height of
the cooker to be aligned with other
kitchen furniture (fig. 4).
• Backguard
1
. If the cookers are
equipped with this accessory, leave of
the factory with this particular inserted
inside the packaging. In order to
install the backguard, it is necessary
to loosen the screws
2
positioned on
the back of the hob and then to fix the
backgaurd as indicated in figure 5
fig. 4
fig. 5
5.2
Gas connection
Before connecting the appliance
check that the data on the rating plate
affixed to the cooker, correspond to
those of the gas mains.
A label on the back of this handbook
and at the back of the cooker gives
the appliance adjustment conditions,
that is, the type of gas and operating
pressure.
When the final connection has been
made, it is essential that a thorough
leak test is carried out on the cooker
and installation.
Ensure that the main connection
pipe does not exert any strain on the
cooker
The appliance must be installed and
serviced by a competent person as
stated in the Gas Safety (Installation
and Use) Regulation Current Editions
and the IEE Wiring Regulations.
Any gas installation must be carried
out by a competent person (GAS SAFE
REGISTER engineer)
to the relevant Gas Standards.
The manufacturer will not accept
liability, should the above instructions
or any of the other safety instructions
incorporated in this book be ignored.
This cooker is designed to be installed
with an appliance flexible connection.
Connection is made to the RC 1/2 (1/2’’
B.S.P.) female threaded located just
below the hotplate level on the rear
right-hand side of the cooker.
• The gas bayonet connector can be
fitted directly behind the appliance
or alternatively adjacent to the
appliance.
• If fitted in a cupboard access must be
available to disconnect and connect
the flexible hose.
• It is recommended that a bayonet
type plug in micropoint flexible hose
is used.
• Recommended length - 4 feet x 3/8
inch bore.
Note:
For certain types of gas bayonet
connection used, it may not be possible
for the appliance to be pushed fully back
to the wall stops.
Important:
Flexible tubing MUST comply with BS.669
Current Edition.
Attention! If the appliance is going
to be recessed (class 2 subclass 1),
connect it to the gas supply source
using only flexible stainless steel,
seamles pipes in accordance with
the standard