33
Left hand door opening
Remove the upper right screw and pivot. Straighten
the safety washer (4) of the lower right hinge. Remove
the screw (5) and the pivot (6) (Fig. 3). For safety rea-
sons bend the washer located under the left hinge
(Fig. 4), by using a tool (for ex. a screwdriver). Remove
the right door stop hinge (3-Fig. 3).
Fig. 4
Fitting the handle
Holes for fitting the handle on the opposite side are
provided, with fixing screws already in place.
Building-in
Recess dimensions
Height
880 mm
Depth
550 mm
Width
560 mm
The appliance’s door has been locked in position
for transport by means of pins on both sides.
According to the door opening direction, remove
relevant pins at the top and at the bottom.
Fig. 5
A i r i s t a k e n i n
through the ventila-
tion grille at the bot-
tom of the appli-
a n c e , b u t a n a i r
outlet “gap”, meas-
uring 50 mm deep
by 540 mm wide
(Fig. 5), must be
provided in the rear
of the kitchen unit.
This outlet gap must also be kept clear between the
top of the unit and the ceiling.
6
5
D563
4
D240
P
H
L
50
540
Fig. 6
Slide the refrigera-
tor into the unit re-
c e s s a n d fit t h e
screws into the top
bracket (Fig. 6) and
i n t o t h e b o t t o m
hinge (Fig. 6).
For safety reasons, minimum ventilation must be as
shown in the Fig. 7.
Attention: keep ventilation openings clear of ob-
struction.
Fig. 7
Inner door reversal
(Only for model ER 1522 P)
Using a screwdriver release bracket (1) by pressing on
the internal spring (Fig. 8) and withdraw it from its seat
together with the door;
remove plug (2) and fit it in the hole left open on the
opposite side;
Fig. 8
t u rn t h e d o o r
through 180
°
, re-
move the bracket
(1) and refit it on the
opposite side.
Refit the door and
insert the top pin
and bottom bracket
(1), pushing it into
place.
To ensure correct
storage of food, the
door is fitted with a simple spring device which holds
it in the open position until it is properly closed.
D585
50 mm
min.
cm
2
200
200 cm
2
min.
D526
PR140
1
2
180°
Содержание ER1522P
Страница 10: ......
