AEG Electrolux CP 33, Руководство по эксплуатации

Страница: 23 / 29

g
43
3
During the cleaning process, the
"Empty grounds container" indicator
(Fig. 3, h)
is illuminated, and the
Coffee Quantity indicators are illumi-
nated alternately. The program runs six
cycles with cleaning liquid. The stand-
ing times are used to allow the clean-
ing tablet to penetrate. In the event of
a power failure or interruption, the
program must be restarted!
The cleaning process finishes after
approximately 8 minutes, when the
Coffee Quantity indicators are
extin-
guished and the "Empty grounds con-
tainer" indicator (Fig. 3, h)
flashes.
0
Empty the coffee grounds container
and re-insert it. The
indicator light
now goes out.
0
Turn the coffee bean container to the
desired position and fill the water tank.
The coffee machine is now ready for
use.
3
After running the cleaning program,
you are advised to throw away the first
cup of coffee from the machine.
15.7 Running the Descaling Program
The descaling program allows you to
simply and effectively descale your
coffee machine. The coffee machine
should be regularly descaled, every 4-6
months, but no later than when the
"Descale" key (Fig. 3, j) indicator
flashes.
1 Important: Do not under any circum-
stances use descalers based on formic
acid or vinegar or pure lemon juice, as
these can damage the appliance. Pow-
dered descalers are not recommended.
Use only AEG descaling tablets.
If other descaling agents are used, AEG
accepts no liability for any damage. You
can obtain descaling tablets from spe-
cialist retailers (E-No. 900195537/7) or
from the AEG Service Line.
The descaling process runs over
two phases and should not be inter-
rupted.
Phase 1: descaling phase, and Phase 2:
flushing phase.
In the event of a power failure or
interruption, the program must be
restarted!
Phase 1: Descaling
0
Before starting the descaling program,
switch the coffee machine off.
0
Remove and clean the coffee-making
unit (refer to „Cleaning the Coffee-
making Unit" page 41). The coffee-
making unit is replaced not until after
the descaling.
0
Replace the service cover.
0
Empty the coffee grounds container
and re-insert it.
0
Pour about 400 ml warm water into
the water tank to just below the lips of
the tank lid, and place a bag (2 descal-
ing tablets) in the water tank
(Fig. 41) .
0
Put the water tank back in place when
the tablets have dissolved. This takes
approximately 5-7 minutes.
0
Switch the appliance on and wait until
it is in the base position.
0
Press the "Descale" key (Fig. 3, j)
for around 3 seconds.
3
During the descaling process, the "Des-
cale" key (Fig. 3, j) indicator is con-
stantly illuminated, and the Coffee
Quantity indicators are illuminated
alternately.
At the end of descaling, the "Fill water
tank" indicator (Fig. 3, i)
flashes.
0
Rinse the water tank out, fill with a
minimum of 1 litre fresh water and
replace it.
Phase 2: flushing
0
Press the "Descale" key (Fig. 3, j) .
The automatic fresh-water flushing
process starts now.
0
The pump switches off automatically,
after the flushing process to the coffee
grounds container is finished. Then the
indicator of the "Steam Pre-selector"
key (Fig. 3, e)
flashes.