AEG Electrolux CP 3, Руководство по эксплуатации, Страница: 27 / 36

g
50
0
Dry the coffee-making unit off and
push the service lever back up to the
stop
(Fig. 32) .
The ejector lever flips in and the cof-
fee-making unit closes.
Inserting the coffee-making unit
0
Follow these steps to re-insert the cof-
fee-making unit:
1. Push the coffee-making unit onto the
guide bar and then unit into the coffee
machine as far as it will go
(Fig. 33) .
2. Press the latching button down and
slide the coffee-making unit back for
around another 1 cm until the latching
button engages
(Fig. 34) .
3. Press the latching lever down to the
stop
(Fig. 34) .
0
Replace and close the service cover,
and re-insert the container.
3 The coffee machine can be switched on
only when the service cover is closed.
After the coffee machine has been
switched on, the coffee-making unit
runs through the set-up cycle, and this
is followed by the normal heating
process.
13.6 Running the Cleaning Program
The cleaning program permits the
intensive cleaning of otherwise inac-
cessible locations. Start the cleaning
program at the latest when you are
instructed by the display indication
«
CARRY OUT CLEANING PRO-
CESS
».
The cleaning process takes ca.
8 minutes and should not be inter-
rupted.
3 Use only original AEG-cleaning tablets!
These can be obtained through the
AEG Serviceline (ET No. 663 910 480) or
your dealer (E No. 950 078 803).
0
Before starting the cleaning program,
clean the brewing unit (see „Cleaning
the Coffee-making Unit“ page 49).
0
Press the „Menu“ key (Fig. 3, f) .
The menu point «
LANGUAGE
»
appears.
0
Press the paging keys or (Fig. 3, c
or d) until the menu point «
CLEAN
»
appears.
0
Confirm the menu point with the „OK“
key (Fig. 3, g). The display shows
«
START CLEANING
».
0
Confirm with the „OK“ key (Fig. 3, g).
The display shows «
PREPARE CLE-
ANING
».
To prepare for cleaning, follow the
instructions in the display.
• «
REFILL WATER – PRESS OK
»
0
Remove the water tank, fill it with
water and replace. Then press the „OK“
key (Fig. 3, g).
• «
BEAN CONTAINER
IN POWDER MODE
»
3 This message only appears when the
bean container is in powder mode.
0
Turn the bean container to the position
„Ground coffee“
(Fig. 35) .
• «
TABLETS IN POWDER HOLDER
– PRESS OK
»
0
Place a cleaning tablet in the powder
holder
(Fig. 36) . Then press the „OK“
key (Fig. 3, g).
• «
WAIT
»
The brewing unit is positioned.
• «
WASTE CONTAINER – PRESS
OK
»
0
Remove and empty container. Then
press the „OK“ key (Fig. 3, g).
• «
CONTAINER
UNDER OUTLET – PRESS OK
»
0
Place the emptied container under the
outlet as shown in
Fig. 37 .
3
The container serves as a collecting
vessel for the cleaning fluid.
0
Press the „OK“ key (Fig. 3, g). The clean-
ing program starts.
822_949_320 CP3500_denepf.book Seite 50 Freitag, 16. September 2005 12:04 00