AEG Electrolux CaFamosa, Руководство по эксплуатации, Страница: 8 / 19

g
21
The individual water hardness settings
(degrees German hardness, ° dH) are
indicated as follows:
The
“Descale“ indicator flashes
( ), in addition the following indica-
tors illuminate ( )
for setting 1 (1°-7° dH): “1 Strong
Cup“
for setting 2 (8°-15° dH): “1
Strong Cup“ and “Ground Coffee“
for setting 3 (16°-23° dH): “1
Strong Cup“, “Ground Coffee“
and “Spent Coffee“
for setting 4 (24°-30° dH): “1
Strong Cup“, “Ground Coffee“,
“Spent Coffee“ and “Clean“
for setting 0 : no further indicators
illuminate. The automatic descale indi-
cator is switched off.
Note: The water hardness setting is
only to be adjusted prior to using the
appliance for the first time, or if the
quality of the water used changes.
Note: The appliance is prepared for the
use of a water filter in the water tank.
With the use of this water filter sub-
stances that spoil the taste of the tap
water such as chlorine, are extracted to
a large extent. In addition the amount
of calcium in the water is greatly
reduced. This lets the flavour of your
coffee develop fully. If the appliance is
operated with water filters, we recom-
mend setting the hardness to setting 0
and descaling it once or twice a year.
1.4. Adjusting the Safety
Cut-Out
If the appliance is not used for an
extended period of time, it switches
itself off for safety reasons and to save
energy.
The appliance has 3 timer settings;
after the expiry of the time set, the
appliance switches off automatically.
The
middle setting 2 (switch off after
2 hours) , is set in the factory.
You can change this setting as follows:
0
Plug the appliance into the mains.
0
Do not switch on the appliance.
0
Press the “2 Cups“ button for
approx. 3 seconds. The “Flush“
indicator illuminates.
0
Pressing the “2 Cups“ button again
adjusts the timer setting by one step to
3, 1, 2 and so on.
0
To save the safety cut-out setting and
end the procedure, press the
“On/
Off“ button. All indicators go out.
If a button is not pressed for more than
30 sec., the procedure is automatically
ended without changing the value
saved previously.
The individual timer settings are indi-
cated as follows:
The
“Flush“ indicator flashes , in
addition the following indicators illu-
minate
for setting 2
(switch off after 2
hours): “Water Tank“ and
“Spent Coffee“
for setting 3 (switch off after 5
hours): “1 Strong Cup“,
“Ground Coffee“, “Clean“,
“Water Tank“ and “Spent Coffee“
for setting 1 : no further indicator illu-
minates, the automatic cut-out is not
activated.
2. Prior to Making Coffee
2.1. Filling the Water Tank
(Figure 4)
Open the lid (Figure 1/A) and remove
the water tank by the handle. Please
only use cold, clear water, and do not
fill beyond the MAX mark.
Then refit the water tank in the appli-
ance and press it down until it engages
so the valve on the base is opened.
For aromatic coffee, you should:
• Change the water in the tank daily,
• Not use mineral or distilled water and
• Clean the water tank at least once a
week in normal washing up water (not
in a dishwasher). Then rinse with clean
water.