AEG Electrolux CaFamosa, Руководство по эксплуатации, Страница: 11 / 19

g
24
one or two cups in the filler opening
(Figure 14).
0
Close the lid.
Note: Add a maximum of 2 portions of
ground coffee. The filler opening for
ground coffee is not a storage con-
tainer. Do not add anything other than
ground coffee!
0
Now press the “1 Cup“ button for
one cup or the “2 Cups“ button
for two cups .
Note: If the “Ground Coffee“ but-
ton is pressed inadvertently, you can
cancel this setting by pressing the
“1 Cup“ button again. The appliance
then performs a normal flush.
4. Frothing Milk (for Cappuc-
cino) (Figure 15, 16)
Hot steam can be used both for froth-
ing milk for cappuccino and for heat-
ing liquids.
Note: For one cup of cappuccino, fill a
large cup up to 2/3 full with espresso
and then add the frothed milk.
Frothing milk:
Slide the moving tube on the swivel-
ling nozzle all the way down (Figure
15/A).
Warming liquids:
Slide the moving tube up (Figure 15/B).
0
Switch on the appliance using the On/
Off switch
(Figure 2/B) and flush if
necessary (see Section 2.5.). The appli-
ance is ready for use when the
“1
Normal Cup“ indicator (Figure 2/D)
illuminates.
0
Immerse the swivelling nozzle in the
container with the milk to be frothed
or the liquid to be heated, and
start
the production of steam by turning the
selection dial (Figure 1/E)
anticlock-
wise to the stop (Figure 16/A).
Due the nature of the system, a little
water runs out of the swivelling nozzle
first, this can be run off first, however
it will not affect the quality of the
result, e.g., on frothing milk.
Important : Only immerse the swivel-
ling nozzle around half way into the
liquid so that air can be drawn in
unhindered. The swivelling nozzle
should not touch the base of the con-
tainer to avoid the hindrance of the
outlet of steam.
Important: There is a
risk of burns!
0
You can stop the outlet of steam by
turning the selector dial clockwise to
the O-position (Figure 16/B).
In particular after frothing milk, it is
recommended to briefly activate the
outlet of steam to “blow out the swiv-
elling nozzle“. Then clean the any milk
residues from the swivelling nozzle
using a damp cloth. Move the moving
metal tube up and down during this
process.
After steam has been drawn off, all
4 green indicators flash to indicate
that the system must be refilled with
water. Proceed as follows:
0
Place a container under the swivelling
nozzle (Figure 1/F).
0
Turn the selector dial (Figure 1/E) anti-
clockwise to the stop (Figure 16/A).
0
Press the “Flush“ button (Figure
2/K). Wait until the flow of water stops
automatically. All 4 green indicators
then flash.
0
Turn the selector dial (Figure 1/E)
clockwise back to the 0-position (Fig-
ure 16/B). The appliance is now ready
for use again.
5. Preparing Hot Water
(Figure 16)
You can use the hot water function for
prewarming cups, for preparing instant
beverages or tea.
Important: There is a
risk of burns!
0
Switch on the appliance using the On/
Off switch
(Figure 2/B) and flush if
necessary (see Section 2.5.). The appli-
ance is ready for use when the
“1
Normal Cup“ indicator (Figure 2/D)
illuminates.