AEE AP11 Pro, Руководство пользователя

Страница: 13 / 31

aee.com
[1]
[3]
[4]
[7]
[8]
[11]
[12]
[14]
[16]
[ 18]
[19]
No. Description
1 Antenna
2 Repeater
3 Mobile device holder
4 Hook open/close button
5
Repeater base
6 Return button
7
Speed switch S1
8
Calibration switch S2
9 Gimbal control switch S3
10 Flight mode switch S4
11 Remote control power indicator
12 Status indicator
13
14 Buzzer hole
15 Strap hole
16 Left joystick
17 Right joystick
18
19
20
21 Remote control power switch
22 Battery compartment
Note:
[2]
[5]
[6]
[9]
[10]
[ 13]
[15]
[ 17]
[20]
[21 J
Figure 12
Specification Definition
Remote control signal transmission
For extending Wi-Fi signal reception range
For attaching mobile devices
Short press it once to open the hook on the quadcopter; press it again to close the hook (Remark: The hook is an
optional accessory)
It is used to fix the repeater
Long press it for 3s to send a go-home command to the quadcopter
There are three speed modes; the speed decreases from up to down: 1. � S Sport mode; 2. fl, D Drive mode; 3. A E
Economic mode;
It is a 3-channel switch. 1.
0K
Uoystick calibration is OK); 2. NULL(Reserved function); 3.,1& (start the joystick
calibration procedure)
/' Lens turns upward (upper position)
Diagram of PTZ motion control switch positions�• Lens stops (middle position)
\. Lens turns downward (lower position)
When it is turned upward/downward, the lens direction changes slowly till the allowable maximum angle is reached
It is a 2-channel switch. 1. GPS@: GPS mode; 2. NRM(t): NRM mode (normal mode);
Remark: When the quadcopter is in the auto fly mode (auto return, low-battery auto landing), at the time when the
remote control signal is restored, switch between the GPS and NRM modes twice to end the auto fly mode and now
the remote control can regain control of the quadcopter
Red, indicating the remote control power ON/OFF status (red light remains on when the power is turned on, and blinks
slowly in low-battery status)
Tri-color indicator
It can indicate the GPS signal status and flight mode of the quadcopter, and also the joystick calibration status.
Remark: For the sake of safety, the quadcopter should be turned off before joystick calibration
Warning tone
Used to hang the remote control
2 channels;"up-down" channel controls gas, "left-right" channel controls yaw.
2 channels;"up-down" channel controls roll, "left-right" channel controls pitch
Slide it to the left position to power OFF the remote control; slide it to the right position to power ON the remote control
It is where the battery is installed
1 ). When the airborne camera is S60 plus, the photo shooting & video recording indicator can only keep remaining on .
.. - ------ ,_ c-c:n o, .. � +ho nhntn c,hnntinn hutton. video recordini:i button and video recording stop button are invalid.
I
\