1
2
ON OFF
3
4
5
Estes-Cox Corp.
1295 H Street, PO Box 227
Penrose, CO 81240-0227
Made In Dongguan, Guangdong,
China
• Do not turn on Proto-X Vid unless controller has been turned on fi rst.
• Keep hands, hair and loose clothing away from spinning blades.
• Turn off controller and Proto-X Vid when not in use.
• Parental guidance is recommended.
• Do not submerge into water. This could damage electronic assemblies.
• Follow operating instructions exactly.
• Not intended for children under 12 years old.
• Replace any damaged or broken parts before attempting to fl y.
• Do not drop the Proto-X Vid by suddenly reducing the throttle.
This could lead to severe damage.
• The Proto-X Vid’s range will also be affected if the battery is not fully charged.
• Do not touch the motors after fl ying. They can become hot.
CAUTION:
Changes or modifi cations to this product not expressly approved by
the party responsible for compliance may void the user’s authority
to operate the equipment.
Do not touch the spinning blades or fl y over another person’s head.
Adult supervision is required.
Battery Requirements for Controller:
Requires: 2 x 1.5V AAA size batteries (not included)
Requirements for USB Charge Cord:
USB Output Jack (not included)
Contents
GET READY TO FLY
Plug the charger into a USB port and the Proto-X Vid as shown.
(The battery connector will only fi t in one way. Do not force the
connectors together.)
The red LED will light when charging.
The red LED will shut off once the charge is complete.
Insert & remove the memory card when
the power is Off.
Turn the Proto X Vid Off or On by holding
the power switch on for 2 seconds.
To take a picture, push down on the right stick for 2 seconds.
The rear red LEDs will fl ash once.
Blue Camera LED fl ashing:
Memory card is not installed.
Start or stop the video by pushing down on the left stick for 2 seconds.
All three red LEDS will fl ash while the video is being recorded.
NOTE:
The video must be stopped
before
the Proto X Vid is turned off.
POWER
SWITCH
MEMORY
CARD
BLUE
CAMERA
LED
VIDEO PICTURE
RED
CAMERA
LED
Make sure that the throttle is
at its lowest position before
turning on the controller.
LED
NEVER
leave the Proto-X Vid unattended when charging.
DO NOT
allow the USB port to power down when connected to the Proto-X Vid.
ALWAYS
unplug the Proto-X Vid when charging is complete.
The Proto-X Vid must be
powered off before charging.
The Proto-X Vid is equipped with a rechargeable 3.7V LiPo battery.
Please pay attention to the following cautions for safe use:
• The battery in the Proto-X Vid is not replaceable.
• Parental guidance is recommended when installing batteries.
• Do not power controller by mixing different types of batteries, or old and
new batteries.
• Use only batteries of the same or equivalent type as those recommended.
• Do not dispose of battery into fi re or heat.
• Do not use or leave battery near a heat source, such as fi re or a heater.
• Do not strike battery or throw it against a hard surface.
• Do not pierce battery.
• Do not disassemble or alter battery.
• Turn off power switch after use.
• Recycle used batteries.
BC
LANDING SAFELY
When the battery voltage begins to run low, the LEDs will begin
to fl ash. It is time to land before the built-in low voltage cut off
reduces power to the motors.
