16
BEFORE ANY SERVICING INTERVENTION, PULL THE PLUG FROM
THE WALL SOCKET.
Place the heat pump on such location, where the
supply cord plug is accessible
any time
. Place the pump on solid, horizontal, non-slip floor. Make sure there is
enough space (at least 2 m
2
) around the pump to allow handling and manipulation.
During installation, use and maintenance, the heat pump should be sufficiently
illuminated (min. 150 lux). Make sure the pump does not present risk to anybody.
Children and persons unacquainted with the operation of the pump should not have
access to the heat pump during its operation.
10. Instructions for safe maintenance
The heat pump will operate without any servicing or maintenance interventions
provided you take into account instructions for safe use and maintenance.
We recommend you check the following:
Check the operation of the safety valve on the cold water tap –unscrew the
cap on the tap until the water starts dripping.
Check of the evaporator fins – dust deposit on the fins will reduce the
efficiency of the heat pump.
In case of dust deposit of the fins,
disconnect the heat pump from power
supply
, loosen the screws, remove the top plastic cover and clean the fins
with vacuum cleaner or purge with air. Be careful not to damage the fins or
other component parts of the heat pump.
Before calling the servicing operator:
Make sure the power supply is in order.
Check for eventual clogging of the air outlet from evaporator through the
grid – this may cause ice formation on the evaporator.
Check the ambient temperature in the room where the heat pump is installed, and
make sure it is within the limits defined in the instructions.
Installation and connection must be carried out in compliance with
the national regulations.
