B-5360 Hardware and Install Manual
Step 3: Route the Cables
Determine whether the cable will pass through a hole on the surface or be routed along the
surface:
If the cable will pass through a hole on the surface
:
1.
Drill the hole for the cable on the surface.
Drill cable hole
within this block.
2. Insert the bundled dome cover tab to the dome cover to close the gap.
3.
Route the cable from the network side through the hole and connect it to the Ethernet port of
the camera.
NOTE:
If the camera will be installed outdoors or in places wherein environmental factors
change drastically, make sure to waterproof the cable connection; see
Step 5: Waterproof
the Cable Connection
on page 14 for instructions.
4.
Push the cable through the the hole on the surface.
12
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
