Advent CAM330, Руководство по установке

Страница: 5 / 12

5
Camera Installation
License Plate Mounting Instructions
1. Remove the rear license plate.
2. Examine the vehicle to determine the best way to run the power wires
to the reverse lights and the extension cable through the car.
3. The Camera can be mounted above or below the plate. (For surface
mounting with the included bracket, see the next section.) Determine
the mounting location that best suits your needs. Be sure to verify that
your installation plan complies with local laws and requirements.
Most states require that the state name, registration stickers, and
license number are not obstructed in any way.
4. Place the camera bracket behind the license plate and line up the
holes. Fasten the camera mounting bracket and the license plate to the
vehicle using the anti-theft screws provided. After installation of
screws with the tool provided, place the tool in the glove
compartment or other safe place for future use.
NOTE: If you decide to mount the camera at the bottom of the license
plate, you must first remove the screw that holds the camera to the
bracket and flip the camera over so the picture will not be displayed up
side down.
5. Route the camera wiring into the vehicle. The wire can be run through
an existing grommet, behind a tail lamp, under the trunk molding, or
if necessary, through a 5/8 inch hole drilled near the vehicle’s rear
license plate.
When choosing a wiring path, make sure the cable
will not be damaged or pinched, as this may cause a short circuit