7
WISE-750 User Manual
C
ha
pte
r 2
In
sta
lla
tio
n
5.
The WISE-750 should be listed in the left column with the IP address labeled. If
you don't see the module be listed, you may check:
a. The Ethernet cable connection
b. Firewall are shut down on both Windows and your anti-virus
c. Seek for local technical support for help
Device Test
Go to the page Device Test to test your device. In this page, you’ll be able to test the
analog input, digital input and digital output functions respectively. Note that in the
runtime, the digital inputs act as trigger and digital outputs act as alarm. The digital I/
O tests here are only to let you test the signal connection and make sure all the con
-
nections work as expected. For detailed signal connection, please refer to section
3.3.
Application
WISE-750 could operate 3 modes, Intelligent, Rule-base and Datalogger mode. To
start with the modes, you should set the running mode in Configuration page then
switch the page to corresponded page for further configuration. For detailed settings
in each mode, please refer to section 4.7.
Note!
You should configure all your IP for WISE-750 one by one before con
-
nect them together. Connect them together in a network will result in
incorrect connection between devices and the utility.
Содержание WISE-750
