SKY-8232D Manual V02 20220411
Copyright 2022 Advantech Co. Ltd. All rights reserved
Page 94
3.3.4 PCIe Card Installation
After removing the top cover and middle bar, follow the instructions below:
1.
If any PCIe cards are already have been installed before, please remove all IO
cables and / or extra power cables connected to the PCIe cards
2.
There are two rear thumb screws for each cage
CG0
,
CG1
,
CG2
to secure the
PCIe cages. Loosen the thumb screws and make sure the thumb screws are fully
disengaged.
Figure 3-31 PCIe Card Cage Assembly: Thumb screw location
3.
To remove the PCIe cage, grab the card cage and pull the card cage evenly and
straight to the top. The pull/push direction must be with an angle of 90
°
from the
PCIe connector. You should feel a small
“bump” when the riser card disengages
with the motherboard. Keep pulling the card cage to the top until it is fully removed
from the chassis and put it on the desk with the riser card connector facing towards
you.
Note!
For
CG0
, press the latch and pull the card cage at the same time.
Remove the PCIe cage in the same way as step 3.
4.
Remove the blank plate(s) on the slot(s) that you want to install a card / cards by
pulling open the latch
○
1
.
5.
Open the latch
○
2
if the card(s) is full length.
Figure 3-32 PCIe Card Cage Assembly: PCIe cage latch
CG0
0
CG1
CG2
Thumb
Screw
Latch
○
1
Latch
○
2
Содержание SKY-8232D
Страница 113: ...SKY 8232D Manual V02 20220411 Copyright 2022 Advantech Co Ltd All rights reserved Page 113 Appendix B BIOS POST Code ...
Страница 128: ...SKY 8232D Manual V02 20220411 Copyright 2022 Advantech Co Ltd All rights reserved Page 128 Appendix E Warranty and RMA ...
Страница 130: ...SKY 8232D Manual V02 20220411 Copyright 2022 Advantech Co Ltd All rights reserved Page 130 Appendix F Glossary ...