6 SKY-6200 Startup Manual
/SKY-6200快速入门手册/SKY-6200快速入門手冊
6. Install the chassis.
As shown, insert the inner member to the cabinet
member. Make sure the ball retainer is in the open posi-
tion. It might cause catastrophic damage to the slides if
ball retainer is not on the front position. After the inner
member goes in, please push up/down the disconnect
lever to unlock the slides, so that you may keep pushing
the chassis to the fully closed position.
Tips.
For EIA square hole die-
casting
Press the latch to transfer
from square to cylinder
(for EIA 7.5 round hole)
Uninstall the bracket
Remove the inner member
1. Read these safety instructions carefully.
2. Keep this User Manual for later reference.
3. Disconnect this equipment from any AC outlet before
cleaning. Use a damp cloth. Do not use liquid or spray
detergents for cleaning.
4. For plug-in equipment, the power outlet socket must
be located near the equipment and must be easily
accessible.
5. Keep this equipment away from humidity.
6. Put this equipment on a reliable surface during installa-
tion. Dropping it or letting it fall may cause damage.
7. The openings on the enclosure are for air convection.
Protect the equipment from overheating. DO NOT
COVER THE OPENINGS.
8. Make sure the voltage of the power source is correct
before connecting the equipment to the power outlet.
9. Position the power cord so that people cannot step on
it. Do not place anything over the power cord.
10. All cautions and warnings on the equipment should be
noted.
11. If the equipment is not used for a long time, disconnect
it from the power source to avoid damage by transient
overvoltage.
12. Never pour any liquid into an opening. This may cause
fire or electrical shock.
13. Never open the equipment. For safety reasons, the
equipment should be opened only by qualified service
personnel.
14. If one of the following situations arises, get the equip-
ment checked by service personnel:
- The power cord or plug is damaged.
- Liquid has penetrated into the equipment.
- The equipment has been exposed to moisture.
- The equipment does not work well, or you cannot get
it to work according to the user’s manual.
- The equipment has been dropped and damaged.
- The equipment has obvious signs of breakage.
15. Do not leave this equipment in an environment where
the storage temperature may go below 0° C (32° F) or
above 35° C (95° F). This could damge the equipment.
The equipment should be in a controlled environment.
16. CAUTION: DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED. REPLACE ONLY WITH
THE SAME OR EQUIVALENT TYPE RECOMMENDED
BY THE MANUFACTURER, DISCARD USED BAT-
TERIES ACCORDING TO THE MANUFACTURER’S
INSTRUCTIONS.
17. THE COMPUTER IS PROVIDED WITH CD DRIVES
COMPLY WITH APPROPRIATE SAFETY STANDARDS
INCLUDING IEC 60825.
18. This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference.
System Setup
/系统安装/系統安裝
Safety Instructions
/安全指示
