Advantech PPC-123, Руководство пользователя

Страница: 54 / 174

PPC-123 User’s Manual 40
4.3 Installing the 2.5" Hard Disk Drive (HDD)
You can attach one enhanced Integrated Device Electronics (IDE) hard
disk drive to the panel PC's internal controller which uses a PCI local-bus
interface. The advanced IDE controller supports faster data transfer and
allows the IDE hard drive to exceed 528 MB. The following are instruc-
tions for installation:
1.
Detach and remove the plastic rear cover and side panel.
2. There is a metal plate which holds the HDD to the upper right-hand
side of the metal shielding case. (See Fig. 4-2.) Remove the two
screws on the metal plate.
3. Pull the metal plate toward the outside of the unit, and remove it
from the two lugs of the shielding case.
4. Place the HDD on the metal plate, and tighten the four screws from
the bottom of the metal plate.
5. The HDD cable (1 x 44-pin to 1 x 44-pin) is next to the metal plate.
Connect the HDD cable to the HDD. The another end of the HDD
cable is connected to the PC board (CN16). Make sure that the red/
blue wire corresponds to Pin 1 on the connector, which is labeled
on the board. Plug the other end of the cable into the IDE hard
drive, with Pin 1 on the cable corresponding to Pin 1 on the hard
drive.
Figure 4.2: Installing the primary 2.5" HDD
2.5” HDD
•
•
Metal plate
Lugs