Advantech PCM-5825, Руководство пользователя

Страница: 27 / 122

Chapter 2 Installation 1 7
4. Gently push the SODIMM into a perpendicular position until
the clips on the ends of the SODIMM sockets snap into place.
5. Check to ensure that the SODIMM is correctly seated and all
connector contacts touch. The SODIMM should not move
around in its socket.
2.7 IDE hard drive connector (CN15)
The built-in Enhanced IDE (Integrated Device Electronics) control-
ler supports up to two IDE devices, including CD-ROM drives, tape
backup drives, a large hard disk drive and other IDE devices. It also
supports faster data transfer, PIO mode 3, mode 4, and Ultra DMA
33 mode.
2.7.1 Connecting the hard drive
Connecting drives is done in a daisy-chain fashion and requires
one or two cables, depending on the drive size. All required cables
are included in your PCM-5825 package. 1.8" and 2.5" drives need
a 1 x 44-pin to 2 x 44-pin flat-cable connector. 3.5" drives use a 1 x
44-pin to 2 x 40-pin connector. However, the required connectors
are not included in the PCM-5825 package.
Wire number 1 on the cable is red or blue, and the other wires are
gray.
1. Connect one end of the cable to CN15. Make sure that the red
(or blue) wire corresponds to pin 1 on the connector, which is
labeled on the board (on the right side).
2. Plug the other end of the cable to the Enhanced IDE hard drive,
with pin 1 on the cable corresponding to pin 1 on the hard
drive. (See your hard drive's documentation for the location of
the connector.)
Connect a second drive as described above.
Unlike floppy drives, IDE hard drives can connect to either end of
the cable. If you install two drives, you will need to set one as the
master and one as the slave by using jumpers on the drives. If you
install just one drive, set it as the master.