2 Startup Manual
Interrupt Settings (JP1, JP2)
Jumpers JP1 and JP2 control the IRQ levels, as shown:
Note:
You must set each I/O line to a different interrupt level.
Interrupt Level (JP3, JP4)
Jumpers JP3 and JP4 select the trigger edge (rising or
falling) for I/O lines PC00 and PC10, respectively.
Jumper settings appear below:
Interrupt Mode (JP5, JP6)
Jumpers JP5 controls interrupt line PC00, and jumper
JP6 controls interrupt line PC10. The DIS setting for
each jumper disables the corresponding line's interrupt
capability. The INT setting enables the line's interrupt
capability. The EXT setting allows you to enable and
disable control by external interrupt.
Software Installation
Hardware Installation
After the device driver installation is completed, you
can now go on to install the PCM-3724 module on your
computer.
Please follow the steps below to install the module on
your system:
1. Touch the metal part on the surface of your
computer to neutralize the static electricity that
might be in your body.
2. Plug your card into a PC/104 slot. Use of excessive
force must be avoided; otherwise the card might get
damaged.
Installation
