Advantech PCM-3342, Руководство пользователя

Страница: 16 / 60

PCM-3342 User Manual 8
2.2.2 Connector Settings
2.2.2.1 Power Connector (CN1, CN2)
Main power connector, +5 V, +12 V (CN1)
Supplies main power to the PCM-3342 (+5 V), and to devices that r12 V.
Reset connector (CN2)
Momentarily pressing the reset button connected to reset connector will activate a
reset.
2.2.2.2 Solid State Disk (CN4)
The board provides a CompactFlash card type I/II socket.
CompactFlash (CN4)
The CompactFlash card shares a secondary IDE channel which can be enabled/dis-
abled via the BIOS settings.
The CompactFlash setting is fix master mode.
2.2.2.3 VGA LCD Interface Connector (CN5, CN6)
VGA/LCD/LVDS interface connections
The board’s PCI VGA interface can drive conventional CRT displays and is capable
of driving a wide range of flat panel displays, including passive LCD and active LCD
displays. The board has connectors to support these displays: one for standard CRT
VGA monitors and one for flat panel displays
CRT display connector (CN5)
The CRT display connector is a box h connector used for conventional CRT displays.
TTL LCD panel connector (CN6)
The board supports 24-bit TTL LCD panel displays.
Users can connect to an 24-bit TTL LCD on it.
2.2.2.4 USB Connector (CN8)
The board provides up to two USB (Universal Serial Bus) ports. This gives complete
plug and play capability. The USB interfaces comply with USB specification Rev. 2.0
which supports 480 Mbps transfer rate, and are fuse protected 5 x 2 pin 180D (M)
connectors for internal 2 x USB connectors at CN8. You will need an adapter cable if
you use a standard USB connector. The adapter cable has a 5 x2-pin connector with
foolproof protection for incorrect plug-in on one end and a USB connector on the
other.
2.2.2.5 SATA Connector (CN9)
PCM-3342 supports Serial ATA via one connector (CN9). Data transfer rates up to
100 MB/s are possible, enabling very fast data and file transfer, and DMA operation
on one port.
2.2.2.6 Power & HDD LED Indicator (CN10)
The HDD LED indicator for hard disk access is an active low signal (24 mA sink rate)
power supply activity LED indicator.
2.2.2.7 LAN Connector (CN11)
Ethernet configuration
The board is equipped with 1 high performance 32-bit PCI-bus Ethernet interface
which is fully compliant with IEEE 802.3 10/100Mbps. It is supported by all major net-
work operating systems.