Advantech IPPC-6172A Series, Руководство пользователя

Страница: 14 / 76

IPPC-6172A User Manual 8
2.1 General
Before you start the computer, please follow these procedures for set up:
1. Check and adjust jumpers on the motherboard (see Chapter 3)
2. Install DDR3 SDRAM
3. Install a CPU
4. Install add-on cards
5. Connect the wires, cables and accessories
6. Mount the computer
7. Program the BIOS settings
8. Install an operating system.
2.1.1 PS/2 Mouse & Keyboard
If you wish to use a full-size desktop keyboard and PS/2 mouse with your panel PC,
follow these instructions:
1. Be sure the panel PC is turned off.
2. Attach the keyboard adapter to the 5-pin purple port on the rear bottom side of
the rear cover.
3. Attach the mouse adapter to the 5-pin green port on the rear side of the cover.
2.1.2 VGA Port
An external VGA-compatible device may be connected to the system via 15-pin
external port on the rear of the unit. The panel PC simultaneously supports an exter-
nal monitor in addition to its own LCD display.
2.1.3 Serial COM Ports
You can easily attach a serial device to the panel PC, such as an external modem or
mouse. Follow these instructions:
1. Make sure the panel PC and any other peripherial devices you mayhave con-
nected to the panel PC are turned off.
2. Attach the interface cable of the serial device to the panel PC's serial port. If
necessary, attach the other end of the interface cable to your serial device. Fas-
ten any retaining screws.
3. Turn on any other peripheral devices you may have connected to the panel PC,
and then turn on the panel PC.
4. Refer to the manual(s) which accompanied your serial device(s) for instructions
on configuring your operating environment to recognize the device(s).
5. Run the BIOS setup program to set the I/O address and IRQ, and configure the
jumper settings to change the mode of the COM ports (refer to section 3.3).
Warning! 1. Switch off and unplug every time you access its interior.
2. The motherboard inside the system is composed of many delicate
ICs, chips and other integrated circuit components. These compo-
nents are easily damaged by static shock.
When you begin to install components, please:
- Avoid touching the metal parts of the motherboard.
- Use anti-static ring when handling CPU or SDRAM module.
- Put SDRAM modules and the CPU inside an anti-static bag or a simi-
lar place before installation.