Installing the the Riser Cards
1.
Remove the screws and HDD bracket signed by the arrows.
移除下图一箭头位置之机箱背面的两颗螺丝，
2. Release four screws and take out the bracket.
3
．
Release screws of the first IO bracket and remove the first IO
bracket.
4. Fix the PCI-e Card on the I/O interface, and insert them into
the Riser Card.
5. Fix 4 screws into the tapped hole signed as the yellow arrow.
Installing the 3.5
’ HDD
1.
Take out the HDD rubbers and screws 6pcs each from the
accessory box ;
2. Fix the rubbers on the HDD bracket as picture shows;
3.
Fix the 3.5
”HDD on the bracket with the screws as below
picture;
4. Make the bracket, which has attached HDD, be set up onto
the original location in the chassis;
5. Take a SATA data cable from the accessory box, and
Installation
