Advantech EKI-6558TI, Руководство пользователя

Страница: 47 / 99

show event P
Show event selection switch#
show event
no event device-cold-start G
Disable cold start event type switch(config)#
no event device-cold-start
no event authentication-failure
G
Disable Authentication failure
event type switch(config)#
no event authentication-failure
no event X-ring-topology-change
G
Disable X - ring topology changed
event type switch(config)#
no event X-ring-topology-change
no event systemlog
I
Disable port event for system log switch(config)#
interface fastethernet 3
switch(config-if)#
no event systemlog
no event smpt
I
Disable port event for SMTP switch(config)#
interface fastethernet 3
switch(config-if)#
no event smtp
show systemlog
P
Show system log client & server
information switch#
show systemlog
3.1.16 SNTP Commands Set
Table 3.17: SNTP Commands Set
Commands Level Description Example
sntp enable
G
Enable SNTP function switch(config)#
sntp enable
sntp daylight
G
Enable daylight saving time, if
SNTP function is inactive, this
command can’t be applied. switch(config)#
sntp daylight
sntp daylight-period
[Start time] [End time]
G
Set period of daylight saving time,
if SNTP function is inactive, this
command can’t be applied.
Parameter format:
[yyyymmdd-hh:mm] switch(config)#
sntp daylight-period 20060101-
01:01 20060202-01-01
sntp daylight-offset
[Minute]
G
Set offset of daylight saving time, if
SNTP function is inactive, this
command can’t be applied. switch(config)#
sntp daylight-offset 3
sntp ip
[IP]
G
Set SNTP server IP, if SNTP
function is inactive, this command
can’t be applied. switch(config)#
sntp ip 192.169.1.1
sntp timezone
[Timezone]
G
Set timezone index, use “show
sntp timzezone” command to get
more information of index number switch(config)#
sntp timezone 22
show sntp P
Show SNTP information switch#
show sntp
show sntp timezone
P
Show index number of time zone
list switch#
show sntp timezone
no sntp
G
Disable SNTP function switch(config)#
no sntp
no sntp daylight
G
Disable daylight saving time switch(config)#
no sntp daylight
3.1.17 X-ring Commands Set
Table 3.18: X-ring Commands Set
Commands Level Description Example
ring enable
G
Enable X-ring switch(config)#
ring enable
ring master
G
Enable ring master switch(config)#
ring master
ring couplering
G
Enable couple ring switch(config)#
ring couplering
ring dualhoming
G
Enable dual homing switch(config)#
ring dualhoming
ring ringport
[1st Ring Port] [2nd Ring Port]
G
Configure 1st/2nd Ring Port switch(config)#
ring ringport 7 8
ring couplingport
[Coupling Port]
G
Configure Coupling Port switch(config)#
ring couplingport 1
ring controlport
[Control Port]
G
Configure Control Port switch(config)#
ring controlport 2
37 Chapter3