3.5
Install the Feed Tube and Fluid Syringe
Material inside the applicator can be near setpoint temperature.
To avoid severe burns, wear protective gloves.
1.
If the syringe is smaller than 30 cc,
insert a syringe spacer ring.
Adapters are available in 3-cc, 5-cc,
and 10-cc.
2.
Check the receiver head O-ring for
wear, debris, or deformity. These
conditions could cause fluid to leak.
Clean or replace if necessary.
3.
Turn
Fluid Air
OFF.
Insert the receiver head into the
syringe and twist to lock.
4.
Attach a new feed tube to the luer
(metal luer shown; selection of feed
tube material depends on the
dispensing fluid.
5.
Attach the feed tube to the syringe
and place the syringe in the jet.
Tighten the thumbscrew to secure.
6.
Slip the feed tube onto the barb end
of the nozzle plate.
CLEAN O-RING
SPACER
RING
THUMB
SCREW
NOZZLE PLATE BARB
3A6244A
Advanjet HV-2100 Jet Setup and Operation
Page 15 of 22
